blossom rot

heather smith

Chillin' In The Garden
Joined
May 7, 2015
Messages
34
Reaction score
1
Points
25
I have an early girl that has ber pretty bad. I have tried all the tricks I have read like adding calcium, Epsom salt, etc. I'm at a loss for what to do. Can I stop it so that any more tomatoes come out ok? I picked all the affected ones and every time I check it there are more that show the blossom end rot. Is it doomed? It's potted by itself in a 5 gallon container currently
 

Ridgerunner

Garden Master
Joined
Mar 20, 2009
Messages
8,229
Reaction score
10,062
Points
397
Location
Southeast Louisiana Zone 9A
BER is normally caused by too much or too little water. Most of the time there is plenty of calcium in your soil, it's just not getting to the fruit where it is needed. Too much or too little water effects how much calcium gets there. The best solution is normally to keep the ground moist without getting it too wet, say using mulch and judicious watering. If it rains a lot you may be put of luck.

It's always nice to have a spoils test to confirm what you have, but if your soil has much clay and is not pure sand, you probably have sufficient calcium.
 

heather smith

Chillin' In The Garden
Joined
May 7, 2015
Messages
34
Reaction score
1
Points
25
It's in a 5 gallon container with a potting mix and soil mix, I water once daily unless it rains and then I don't water it. But the bottoms of the fruit all are brown or black and rotted
 

Beekissed

Garden Master
Joined
May 15, 2008
Messages
5,054
Reaction score
6,801
Points
377
Location
Eastern Panhandle, WV
I wouldn't water it daily but I would cover the soil with something that retains moisture....mulch, grass clippings or some such. I'd wait until the soil dries out pretty well before watering, then I'd water it deeply and thoroughly.

I didn't know this until this year, but magnesium can inhibit the uptake of calcium so they are not to be applied together...gardened all these years without knowing that. Said to apply the calcium to the soil and then wait until the plant blossoms before using use the epsom salts as a foliar spray. Will try that this year and see what happens.
 

heather smith

Chillin' In The Garden
Joined
May 7, 2015
Messages
34
Reaction score
1
Points
25
I wouldn't water it daily but I would cover the soil with something that retains moisture....mulch, grass clippings or some such. I'd wait until the soil dries out pretty well before watering, then I'd water it deeply and thoroughly.

I didn't know this until this year, but magnesium can inhibit the uptake of calcium so they are not to be applied together...gardened all these years without knowing that. Said to apply the calcium to the soil and then wait until the plant blossoms before using use the epsom salts as a foliar spray. Will try that this year and see what happens.[/QUOTE
how did you apply calcium? I wonder what works best
 

seedcorn

Garden Master
Joined
Jun 21, 2008
Messages
9,650
Reaction score
9,974
Points
397
Location
NE IN
Agree. Probably over watering. I know this will sound stupid, use a little milk with water when plant shows signs of needing water. Can pour milk right on plant.
 

dickiebird

Garden Addicted
Joined
Mar 22, 2009
Messages
1,102
Reaction score
880
Points
257
Location
Cedar Hill MO
I find that as your tomato production increases the BER decreases and finally stops.
Cutting back on the water will help more than anything.

THANX RICH
 
Top