Your Weather, 2024

Rhodie Ranch

Garden Master
Joined
Nov 19, 2009
Messages
3,596
Reaction score
5,990
Points
333
Location
Southern Washington State, 8b
Massive amounts of rain forecasted all week. Since hubs didn't want to put in a french drain along the side of the metal shop, it WILL flood again in there, like it did last winter. The downslope normally drains well, but if there is alot of rain all at once, it seeps into the shop. OH WELL....
 

digitS'

Garden Master
Joined
Dec 13, 2007
Messages
26,697
Reaction score
32,401
Points
457
Location
border, ID/WA(!)
My "French drain" was the easiest thing imaginable although it might not be adequate for your needs, @Rhodie Ranch . It primarily came about because I had a lot of those bricks with holes in them and, yes, a wet basement floor along the west side wall, primarily during times of snowmelt.

After digging a narrow and shallow trench, I set a plastic roof gutter in the ground. At the end, I dug down about two feet and a filled the bottom of the hole with a few large boulders. I covered them with some of the soil and covered the gutter with those bricks.

It worked. But, about 15 years later the house was re-roofed and I had the contractor put a roof gutter along that side. The drain is still there. It isn't really needed but the bricks form a border for the lawn with wood chips against the basement wall.

Steve
 

Dahlia

Deeply Rooted
Joined
Nov 24, 2020
Messages
1,756
Reaction score
4,726
Points
195
Location
Pacific Northwest
We have your snow/rain this morning, Ducks'.

It is 36⁰f (so, 2⁰C above freezing). The snow is on the lawn but, really, nowhere else. Several hours before sunrise and with 90% sky cover and an 80% chance of rain for the day, won't amount to much.

digitS'
We got some heavy winds yesterday and last night accompanied by rain, but now it is just calm and cloudy.
 

flowerbug

Garden Master
Joined
Oct 15, 2017
Messages
16,928
Reaction score
26,496
Points
427
Location
mid-Michigan, USoA
for about 20yrs our garage door would not keep the rain water from seeping in, the cement contractor did not angle the lip downwards to keep the water out. so one year i finally got some mason cement and made a sloped lip downwards to where the garage door came down.

it is not 100% reliable if we get a really heavy driving wind (the garage door faces the west so that is the place we do most likely get winds from as they come whipping up the driveway) some water may still come through but at least it is rarely enough to worry about.

after the cement was cured i got some good garage floor paint and put several coats over it. so far it has held up ok.

oh, yes, the current version is the third attempt. the first one was a small ridge which was just not enough to keep much of anything out. the 2nd attempt did not stick to the slab even with my cleaning, grinding and other prep, the last attempt i mixed some kind of flexible binder in with the cement.
 

Shades-of-Oregon

Deeply Rooted
Joined
Jul 22, 2024
Messages
848
Reaction score
2,447
Points
145
Burn ban lifted in PNW. I don’t burn anymore to much pollution. I just turn the burn pile with the tractor front scoop and it all turns to black rich compost.
Rain off and on today. High 49-F .. Low 41F snow level at 3500’
Ski season open in the mounts Mt. Hood, and Batchelor…9000’.
 

Alasgun

Deeply Rooted
Joined
Jan 11, 2021
Messages
1,293
Reaction score
5,370
Points
195
Location
S. Central Alaska
for about 20yrs our garage door would not keep the rain water from seeping in, the cement contractor did not angle the lip downwards to keep the water out. so one year i finally got some mason cement and made a sloped lip downwards to where the garage door came down.

it is not 100% reliable if we get a really heavy driving wind (the garage door faces the west so that is the place we do most likely get winds from as they come whipping up the driveway) some water may still come through but at least it is rarely enough to worry about.

after the cement was cured i got some good garage floor paint and put several coats over it. so far it has held up ok.

oh, yes, the current version is the third attempt. the first one was a small ridge which was just not enough to keep much of anything out. the 2nd attempt did not stick to the slab even with my cleaning, grinding and other prep, the last attempt i mixed some kind of flexible binder in with the cement.
Loc-tite makes numerous cement repair solutions, ive had great sucess with several of them (magna-crete); all large doors in industrial shops where inward water flow was a constant problem. In all cases i trowled a smooth rounded ridge 6-8 inches wide and an inch tall across the opening. These repairs have lasted many years without problem, enduring daily forklift trafic!
 
Last edited:

Latest posts

Top